SIFAT PEMESINAN 34 JENIS KAYU DARI MALUKU & SULAWESI TENGAH
Abstract
The machining properties of 34 wood species tested according to the ASTMD 1666-64 procedure are presented in this paper. The machining properties studied were planing, shaping, turning, sanding, boring and mortising.
Some of the species tested (such as suling, gohimahou etc.) are consistently better than average in most respects and some are consistently poorer (such as telor, andolia etc.). Some are good in one property or two and poor in others. These differences are probably due to differences in the specific gravity values of each speciesKeywords
Full Text:
PDF (Bahasa Indonesia)References
Anonymus, 1974. Standard Method of Machining Test and Wood Base Material. Annual Book of ASTM. Philadelphia.
Akub. J.A. dan Karnasudirdja. S, 1982. Sifat Pemesinan Kayu - Kayu Indonesia. Laporan BPHH No. 160. Bogor.
Koch. P, 1964. Wood Machining Process. The Ronald Press Co. New .York.
Oey Djoen Seng, 1964. Berat Jenis dari jenis-jenis kayu Indonesia dan pengertian berat kayu untuk keperluan praktek. Pengumuman LPHH No.1. Bogor.
Untung. S.A, 1984. Studi pendugaan sifat pemesinan kayu melalui beberapa sifat fisis, mekanis dan anatomisnya. Skripsi. Fakultas Kehutanan, IPB. Bogor.
DOI: https://doi.org/10.20886/jphh.1985.2.3.27-36
Refbacks
- There are currently no refbacks.
JURNAL PENELITIAN HASIL HUTAN INDEXED BY:
Copyright © 2015 | Jurnal Penelitian Hasil Hutan (JPHH, Journal of Forest Products Research)
eISSN : 2442-8957 pISSN : 0216-4329
JPHH is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.