SIFAT PEMESINAN BEBERAPA JENIS KAYU DARI DAERAH KALIMANTAN BARAT DAN JAWA BARAT
Abstract
Machining properties of 16 wood species from West Kalimantan and West Java has been identified using the modified ASTM D-1666 which was described in the Forest Products Research Institute Report No. 160 (1982). The samples (25 pieces/species) were dried to equilibrium moisture content condition (15 to 18% of MC). The machining properties tested are planing, shaping, boring, turning and sanding.
Seven species that have good to very good machining properties are kenari I, kenari II, kemayau, belangeran, ki sampang, ki endog and surian bawang. The best machining properties, however, were found on johar, gadog and putat. Whereas the other species are good or very good in some properties and fair or even poor in others,
Full Text:
PDF (Bahasa Indonesia)References
ASTM. 1974. Standard Method of Conducting Machining Test of Wood based Material. Annual book of ASTM. Philadelphia.
Akub, J.A. dan S. Karnasudirdja. 1982. Sifat pemesinan Kayu-kayu Indonesia. Laporan BPHH No. 160, Bogor, Koch, P. 1964. Wood Machining Process. The Ronald Press Co. New York.
Oey Djoen Seng. 1964. Berat jenis dan jenis-jenis kayu Indonesia dan Pengertian Berat Kayu Untuk Keperluan Praktek, Pengumuman LPHH No. 1., Bogor.
Pringle, S.L. 1978. Quantity and quality of tropical forests. Proceeding conference on improved utilization of tropi- cal forests. FPL Madison, Wis.P : 52-68.
Rachman, Osly. 1981. Himpunan sifat pemesinan jenis-jenis kayu Indonesia. Tidak diterbitkan. Dokumentasi Disiplin Penggergajian dan Pengerjaan. Puslitbang Hasil Hutan,Bogor.
DOI: https://doi.org/10.20886/jphh.1989.6.3.187-198
Refbacks
- There are currently no refbacks.
JURNAL PENELITIAN HASIL HUTAN INDEXED BY:
Copyright © 2015 | Jurnal Penelitian Hasil Hutan (JPHH, Journal of Forest Products Research)
eISSN : 2442-8957 pISSN : 0216-4329
JPHH is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.